Iris Motion Sensor (Previous Generation)

Iris Motion Sensor (Previous Generation)

Iris Motion Sensor (Previous Generation)

Lowe's Item #388557
Manufacturer Model # MOT501
Powered by CR2 Battery
Type of Wireless Communication - Zigbee
Note: This device is compatible with both Iris 1st Generation Hubs and Next Gen Hubs

Pairing Device to the Iris Hub

Step 1: To begin, you should be in the same room as your hub. In the Iris app, go to the "Add" section, tap "Device," and browse or search for the device. This will put the hub in pairing mode, indicated by a blinking green light.

Step 2: Remove the back by squeezing the raised edges.

Step 3: Install the battery on top of the battery tab.

Step 4: Put the cover back, ensuring it snaps on.

Step 5: The sensor's LED will blink while searching for the hub.

Step 6: When the hub triple beeps, your device has been paired. Now let's install it.

Step 7: The angled back makes it convenient to mount in a corner, or on a flat wall. The important thing is to locate the sensor about chest high with nothing blocking its view.

Step 8: Make sure the surface is clean and dry.

Step 9: Add the mounting adhesive to the back, or the angled back if you plan to put it in a corner.

Step 10: Press and hold it against the wall for 10 seconds, and you're done.


Factory Reset Instructions
 
Use Case: When the device has been force removed from the App or the device has pairing and/connectivity issues.
 
Step 1: A factory reset is useful when a device has pairing or connectivity issues, or if you have just force removed the device within the app.

Step 2: To begin, remove the battery and wait 10 seconds.

Step 3: Reinsert the battery and press the white reset button 8 times, allowing one second between each press.

Step 4: To re-pair the device, put the hub in pairing mode by tapping the plus sign on the dashboard, and the DEVICE.

Step 5: The hub will triple beep when pairing is complete.



FAQs


Next Gen - What if my hub does not have enough range to reach all of my devices?

Troubleshooting
 
Step 1: Verify the device you are attempting to pair is located in the same room as your hub.

Step 2: Make sure your hub is in pairing mode by checking to see if there is a blinking green light on the hub. If it is not in pairing mode, try re-selecting the device you are pairing in the app. If this does does not cause the hub to blink green, go ahead and reboot the hub by holding down the red button on the back of the hub approximately 3 seconds. Once the hubs light goes back to solid green, re-attempt the repairing process in the app.

Step 3: If the first two steps fail, follow the factory reset and repairing steps for your given device shown above. 
Rating:Rating of 2 Stars10 Votes
Was this answer helpful?YesNo
Topic Information
  • Topic #: 30143-625
  • Date Created: 02/05/2016
  • Last Modified Since: 08/15/2016
  • Viewed: 5175

SUPPORT

Help & Resources for
Your Iris Smart Home

To check the status of the Iris platform, click here.

Contact Us

Questions about Iris? Call us now for immediate assistance.
Hours of operation: 8am – 1am EST

1-855-469-IRIS