Insert the plug-in dimmer into the outlet where you intend to use it.
Press the button on the front of the dimmer. The hub will beep when pairing is complete.
TIP: Do not use other Iris devices at this time to avoid removing them. It is best if the device is within 10 feet of the hub.
1. Press the button located on the front of the dimmer.
2. The hub will beep when the device is successfully removed.
Unplug the module and wait 5 seconds.
Plug the module in and within 20 seconds press and hold the programming LED Button until the LED turns Amber and then turns Red. The module is now reset and the LED Button can be pressed again to initiate "pairing"